What size expansion tank do I need?
What size expansion tank do I need?
General Guidelines for Sizing an Expansion Tank
| Water Heater Capacity | Supply Pressure (psi) | Expansion Tank Size |
|---|---|---|
| 40 to 60-gallon | 40-50 psi | 2-gallon |
| 40 to 60-gallon | 60-80 psi | 3.2-gallon |
| 80-gallon | 40 psi | 2-gallon |
| 80-gallon | 50-60 psi | 3.2-gallon |
How do I know if my thermal expansion tank is bad?
How to Tell If an Expansion Tank is Working
- Tap on the tank. It should be hollow about half way up.
- Check the temperature by feeling the top and bottom of the tank. The tank should be warm on the bottom and cool on the top if it is working properly.
- Use an air gauge to check the pressure inside the tank.
Is a thermal expansion tank required by code?
The California Plumbing Code (Section 608.3) and the California Mechanical Code (Section 1005.0) requires a thermal expansion tank, or listed equivalent, to be installed to water heating systems to relieve excessive building pressure during the heating process.
How much is a thermal expansion tank?
The cost to install a thermal expansion tank can range from $300 to $400. Often the expense of the thermal expansion tank is included in the cost of the new water heater.
What happens when the expansion tank fails?
Oftenthe diaphragm dividing the two systems will fail, causing the two systems to become one. When this happens, the expansion tank turns into a “dead leg” that will eventually cause damage and premature failure to your water heater.
Will a bad expansion tank increase water pressure?
The expansion tank contains air, which is highly compressible. Expanding water from the water heater can flow into the expansion tank, where the air compresses, making room for the increased volume of water. Water pressure in the system doesn’t increase significantly.
How long should expansion tank last?
between five and 10 years
But expansion tanks can wear out. The average life of your tank can be anywhere between five and 10 years. You can extend the life of your expansion tank by making sure that your home’s water pressure matches the air pressure in your expansion tank.
Are expansion tanks worth it?
An expansion tank is always highly recommended if you have a ‘closed-loop system’ caused by any kind of check valve or pressure regulating valve installed on your house’s water supply line. However, the long-term wear and tear of this excess pressure can reduce the life expectancy of everything in your plumbing system.
Does expansion tank go on hot or cold side?
Although expansion tanks can be installed on the hot side, we strongly recommend they be installed on the cold line, downstream of the shutoff valve.