What is the default password for Buffalo TeraStation?

admin
Turning the TeraStation On and Off Note: The default username and password are “admin” and “password”.

How do you reset a Buffalo TeraStation?

To reset the TeraStation to its factory default settings, power on the unit and hold down the reset button for five seconds. In the Web Admin interface, you can initialize almost all settings, including things that are not initialized from the reset button without the data saved in the TeraStation.

How do I access Buffalo TeraStation from the Internet?

Connect the LinkStation to your network with an Ethernet cable and power it on. Launch a web browser and enter the LinkStation’s IP address into the address bar to access Settings. If you do not know the LinkStation’s IP address, you can use NAS Navigator to access Settings instead.

How do I find my buffalo IP Address?

Log in to Settings. From Settings, click the “Advanced Settings” tile. Click the “Network” tab on the left. Click on the widget to the right of “IP Address”.

How do I connect to my Buffalo NAS drive?

Mapping a Drive to a Buffalo NAS in Windows

1. Open NAS Navigator.
2. Right-click on the NAS.
3. Select “Browse Shares” from the pop-up menu.
4. Right-click on the shared folder you want to map to a drive letter.
5. Select “Map network drive…” from the pop-up menu.
6. Click on the drop-down menu to change the drive letter if desired.

How do I turn off Buffalo TeraStation?

Turning the TeraStation On and Off

1. Press the power button on the TeraStation to turn it on.
2. To turn off the TeraStation, press and hold down the power button for three seconds until it beeps.
3. You can also shut down or restart the TeraStation remotely from.
4. When the power LED turns off, the shutdown process is completed.

How do I add a Buffalo NAS to my Network?

What is the IP Address for Buffalo router?

192.168.11.1
How do I access the configuration interface of the AirStation?

How do I connect to Buffalo?

Knowledge Base

1. Connect the LinkStation to your network using the supplied Ethernet cable.
2. Plug in the AC adapter and connect to the LinkStation.
3. Power on the LinkStation by moving the switch on the rear of the unit to “On”.
4. Open NAS Navigator.
5. Right-click on the LinkStation and choose “Settings” from the pop-up menu.