How do you size a hearing aid tube?

Place the hearing aid behind you ear and insert the mould into your ear. Then measure where the tube needs to be cut. Mark the area where the tube needs to be cut and cut the tube after taking the mould out from the ear. Make sure that you do not cut the tube too short.

How often should you change hearing aid tubes?

approximately every 6-9 months
You should replace the plastic tube inside your earmould approximately every 6-9 months, or when the tube becomes discoloured and hard. This will help to maintain good sound quality and comfort. If the tube becomes too hard it can snap and get stuck inside the mould.

How do you trim Earmold tubing?

Use scissors to cut just above where you marked. Cut conservatively, above the line you drew. You can always trim more tubing off if it’s still too long but you can’t add it back on. Attach newly trimmed (short) tubing from the earmold to the top notch of the earhook of the hearing aid.

How often should I change my hearing aid tubes?

How long does it take to repair a hearing aid?

Indeed, hearing aid repairs can be performed in no less than thirty minutes. However, the issue may also be complicated, and if that’s the case, it could take a couple hours at least. You may even be asked to leave the hearing aids with them for repair if they do not have the right part they need.

What is the purpose of a dome on a hearing aid?

Hearing aid domes are small, bell-shaped, or mushroom-shaped silicone articles that are attached to the end of the hearing aid tube or wire. Their main task is to improve the performance of the device and properly fit in the ear canal. Hearing aid domes are used in conjunction with a behind-the-ear type of devices.

How are earmolds worn with a hearing aid?

Soft, dome-style earmolds are often paired with BTE hearing aids, and are worn in the ear canal. A BTE hearing aid is worn behind the ear, and transmits sound to the earmold via a thin, flexible tube. Earmold styles vary according to level of hearing loss, and the style of hearing aid with which they’re paired.

How do you remove mold from hearing aid?

First, you want to make sure that you wash your hands and then remove the ear mold from the hearing aid. Take note of the angle that the tubing is at. You want it to be nice and flush with your ear mold. Remove the tubing from the ear mold. Keep the old tubing as you’ll need it later.

How do you adjust an ear mold for hearing?

1. Pull the old tube off the end of the elbow while the elbow is still in the mold. 2. Add a new piece of tube to replace the old one. In the event that an ear mold needs to be adjusted, the following instructions will serve as a guideline. 1. Check the ear mold canal for a bulbous portion.

Do you have to widen tubing for BTE hearing aid?

If you have concerns about cutting the proper length, always cut a little longer. You can come back and adjust as needed. Then take the new ear mold tubing and attach it to the hearing aid. If you have difficulty getting it on, you can grab your pliers and widen the tubing.