How to Setup Iomega StorCenter ix2?

Quick Install

1. Use the included network cable to connect the drive to your network router.
2. Use the included power cord to plug the StorCenter ix2 into your surge protected power source.
3. The device will power on automatically.
4. From a computer on your network, open a web browser and go to www.myiomega.com to set up your.

How do I reset my Iomega StorCenter ix2?

Factory Reset

1. Choose one of the following options: Preserve users and folders.
2. From the After Reset drop-down menu, choose to Restart or Power off the Iomega StorCenter ix2-200 after the factory reset completes.
3. Click Apply.
4. In the pop-up confirmation, click Yes to perform the factory reset.

How do I reset my ix2 DL?

All you need to do is to reset your StorCenter ix2-dl modem. This can be done easily by clicking on the reset button at the back or at the bottom of your router. If you hold down this small button for approximately 20 seconds, (you may have to use a toothpick), then your modem will get restored to the factory settings.

What is Iomega hard drive?

The Iomega HDD is about average size for an external 5.25-inch desktop enclosure: 7.75 inches by 4.75 inches by 1.6 inches (LWH). The Iomega HDD draws too many watts to run off of bus power, so Iomega provides an AC adapter, along with USB 2.0 and FireWire 800 cables; oddly, the package lacks a FireWire 400 cable.

How do I connect my Iomega to my computer?

Iomega portable hard drives connect to your computer through a USB port. When you connect the Iomega hard drive to your computer, it should pop up as an icon in your My Computer folder. If you can’t find the icon in your My Computer folder then you probably need to update the driver for the device.

How do I reset my Iomega external hard drive?

1. Expand the notification area on the taskbar and then double-click the Iomega Storage Manager icon.
2. Click the gear icon to open the Home Media Network Hard Drive Console.
3. Select “System” from the left pane and then click “Factory Reset.”

How do I reset my ix2-DL?

How do I reset my Iomega StorCenter ix2-200 password?

Resetting the administrator password

1. To reset the Iomega StorCenter ix2-200 press the small recessed button on the back.
2. When your Iomega StorCenter ix2-200 device finishes restarting, open the Iomega StorCenter ix2-200 Console.
3. Complete the Device Setup as described in Setup.

How do I reset my Lenovo Iomega ix2?

Lenovo Iomega IX2-DL

1. Run ix2-ng-4.1.408.34845.exe.
2. Disconnect the lan and power cables.
3. Plug in the usb.
4. While holding the RESET button plug in the power adapter and hold it for about a minute.
5. When the led on the usb starts flashing, showing that the system is reading the USB-disk, release the reset button.