How do I enable AHCI in registry?

Method #1: Enable AHCI mode through the registry You can do it by right-clicking on the “Start” button and then selecting “Run“. In the text field, you should enter the command regedit and confirm it with the button “OK“.

How do I change IDE mode to AHCI?

Right-click the Windows Start Menu. Choose Command Prompt (Admin). Restart the computer and enter BIOS Setup (the key to press varies between systems). Change the SATA Operation mode to AHCI from either IDE or RAID (again, the language varies).

How do I know if AHCI is enabled?

Check for an entry that contains the acronym “AHCI.” If an entry exists, and there is no yellow exclamation mark or red “X” over it, then AHCI mode is properly enabled.

Can I change to AHCI after install?

In UEFI or BIOS, find SATA settings to select the mode for memory devices. Switch them to AHCI, save settings and restart the computer. After the restart, Windows will start installation of SATA drivers, and when it is over, it will ask you for another restart. Do it, and AHCI mode in Windows will be enabled.

How do I start Windows in AHCI mode?

How to enable AHCI in Windows 8.1 and 10?

AHCI in Windows 8.1 and 10 via storahci! For this purpose, please enable AHCI via registry in the Windows 8.1 / 8! In Windows 7, it was still called Msahci.sys! But this as a sideline! To run the registry in Windows 8.1 and 8, press the [Windows + R] key combination, then simply enter the text regedit and confirm the command by pressing Enter!

How to enable AHCI in the Registry Editor?

Enable AHCI using Registry Editor 1 While in Windows, press the Win + R keys to open Run, type regedit into Run, and click/tap on OK to open Registry Editor. 2 If prompted by UAC, click/tap on Yes. 3 In the left pane of Registry Editor, browse to the key location below. (see screenshot below)

Do you need to enable AHCI in BIOS / UEFI?

If you wanted to install Windows using AHCI instead of IDE, then you would normally need to have AHCI enabled in BIOS/UEFI first. This tutorial will show you how to enable AHCI in Windows 8/8.1 and Windows 10 after you have already installed the OS (operating system) with IDE by mistake.

How do I set my Disk Controller to AHCI?

This is a two step process, the first step involves changing the registry, the next step involves setting disk controller type to AHCI from BIOS. Hold the Windows Key and Press R . In the run dialog box, type regedit and click OK. From the left pane in registry editor, go to HKEY_LOCAL_MACHINE > SYSTEM > CurrentControlSet > Services > storahci .