Questions and answers

How do I reset my Whirlpool Cabrio washer?

How do I reset my Whirlpool Cabrio washer?

To reset a whirlpool cabrio washer, begin by setting the dial to “normal.” Turn the dial left until you hear a click, then right for three clicks. Turn the dial left for one more click. Press “start” once and rotate the dial until all the lights turn on. Turn off and unplug for 10 minutes.

Why does my washing machine keep saying uneven load?

If a top load washer’s tub begins to bang against the sides of the washer when the spin cycle begins (before reaching top speed), this indicates a likely unbalanced load. Just pause the cycle and arrange the clothes in the basket and try again. A similar issue occurs in front load washers as well.

Why is my Cabrio washer not working?

This is usually caused by a clog in the drain line or something obstructing the pump. Clean out any lint or obstruction (coin, small button) that is clogging the pump filter. Turn off the water connections. If these steps don’t solve the problem, the washer’s water pump may need to be replaced.

Can you rebalance a washing machine?

Leveling a Washing Machine By placing a level on top of the machine, you can adjust the feet of the washer, not the actual floor, to make the machine level. This means that even if the floor itself is not level, you can compensate by adjusting the machine feet to be just right.

Why does my Whirlpool Cabrio washer keep saying uL?

If uL (unbalanced load) appears in display, the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.

Why won’t my Cabrio washer fill with water?

If you find your Whirlpool Cabrio washer not filling with water, the inlet hoses and screens may be at fault. The hoses connect the main water supply to your machine. To inspect the screens for signs of clogging, turn off the main water supply. Then, detach the inlet hoses from both the washer and the faucet.

What’s wrong with my Whirlpool Cabrio washer?

How do I know if my inlet valve is bad?

Signs that point to an inlet valve problem include leaks that fill the dishwasher when not running, the dishwasher filling too slowly when in use, or the dishwasher not filling at all. Leaks that end up outside of the dishwasher also can indicate an inlet valve problem, and this must be addressed immediately.

What is the problem code DL on the Cabrio washer mean?

The Cabrio Washer DL error code happens when the main control detects a problem with the lid lock assembly not being able to lock properly or the control cannot determine if the door lock assembly is in a locked or unlocked state. The steps to take to try and remedy this error are below.

What does ul code mean on a whirlpool washer?

Whirlpool Cabrio Washer Error UL. The Cabrio Washer UL error code stands for un-balanced or off-balanced load which means the control has recognized the the tub is off balance during the spin cycle. This code will be shown as the washer control tries to balance out the load if its successful Cabrio Washer Error UL will clear from the display,…

What does F1 code on Whirlpool Cabrio washer mean?

The F1 error code on a Whirpool Cabrio washer means that water level pressure switch that is built into the computer board on those models is sending an incorrect signal to the board.

What does LD mean on Whirlpool Cabrio washing machine?

Whirlpool Cabrio Washer Error LD. The Cabrio Washer LD error code stands for Long Drain which means the control has recognized the water in the tub is not draining fast enough during the cycle.