Other

How do I tune my Sony Trinitron TV?

How do I tune my Sony Trinitron TV?

Press the [HOME] button of your remote controller. Go to the Settings menu, located at the bottom of the Home screen. Select Channel Setup → Digital Setup → Digital Tuning → Digital Auto Tuning. When asked “Do you want to start Auto Tuning?”, select Yes.

How do I tune my old Sony TV?

Digital tuning

  1. Press the [HOME] button of your remote controller.
  2. Go to the Settings menu, located at the bottom of the Home screen.
  3. Select Channel Setup → Digital Setup → Digital Tuning → Digital Auto Tuning.
  4. When asked “Do you want to start Auto Tuning?”, select Yes.
  5. Make your selection between Antenna or Cable.

How do I manually tune my Sony TV?

Steps

  1. Make sure that the antenna (aerial) cable is properly connected to the TV.
  2. Press the HOME button, then select [Settings].
  3. Select [Digital Set-up] → [Digital Manual Tuning].
  4. Select [Scan Type], then select [Channel] or [Frequency].
  5. Set the other items accordingly.
  6. Select [Scan Up] or [Scan Down].

Why can’t I tune my Sony TV?

If your Sony TV channels are not working, are not finding, or are losing, you can either retune the channels on the TV, perform an electrical reset, complete a factory reset, update the TV with the latest firmware, replace batteries within your remote, or reset your remote control.

What is auto tuning in Sony TV?

Press the HOME button, then select [Settings]. Select [Digital Setup] → [Digital Auto Tuning]. Follow the on-screen instructions to tune in all available digital channels and store their settings in the TV.

Does Sony Bravia have built in Freeview?

Freeview and Sony have announced the successful roll out of Freeview Play on selected Sony Bravia TVs. The catch-up and on-demand platform provides access to BBC iPlayer, ITV Hub, All 4, Demand 5 and UKTV Play.

Why is my TV not tuning?

First check that your TV is set to the correct Source or Input, try changing the Source or Input to AV, TV, Digital TV or DTV if you haven’t already. If your “No Signal” message is not due to incorrect Source or Input being selected, then it’s most likely caused by a set up or antenna fault.