Trending

How often should I grease drive shaft?

How often should I grease drive shaft?

A good guideline to start with is to grease your shaft every oil change. If you go wheeling and drive through a lot of dirt or water, grease your shaft as soon as you get home.

Should I grease prop shaft?

Greasing the prop shaft helps prevent the hub kit from sticking.

How often should you grease prop shaft?

A good guideline to start with is to grease your shaft every oil change. If you go wheeling and drive through a lot of dirt or water, grease your shaft as soon as you get home. This will flush out the contaminants before they have a chance to do much harm.

Can you over grease a drive shaft?

Can you over grease a drive shaft? If you pump too much grease into the U-joint zerks, they old grease just oozes out with a crackling sound. One thing you can try if the slip yoke is overgreased is to remove the zerk, then drive up & down a curb or 5mph speed bumps.

Can you over grease a slip yoke?

“For those that don’t know, It is EXTREMELY important that you not put too much grease into the slip yoke. Filling this area completely with grease prevents the driveshaft from shortening with normal suspension movement. This can quickly destroy your transfer case output shaft bearings and even diff pinion bearings.

Should you lubricate drive shaft?

So initially, all you need to do is install it. Down the road however you will need to grease your drive shaft to ensure a long life. A good guideline to start with is to grease your shaft every oil change. If you go wheeling and drive through a lot of dirt or water, grease your shaft as soon as you get home.

What type of lubricant grease can be used on universal joints?

What type of grease should I use to lubricate my universal joints equipped with grease fittings? A good quality lithium complex soap based EP (Extreme Pressure) grease with a NGLI grade of 1 to 2 is recommended.

Do you need to lubricate the propeller shaft on a 4Runner?

Propeller shaft lubrication is a very simple maintenance procedure to do, but it is often avoided because cleaning the grease off between the spider joints can be a bit tedious. Keeping the propeller shafts properly lubed will ensure the longevity of a critical component in your 4Runner.

What are the propellers on a 5th Gen 4Runner?

For the 4X4 5th Gen 4Runner driveline, there are two propeller shafts; for reference, these two shafts will be referred to as FWD (forward) and AFT propeller shafts in this write up. Each prop shaft consists of 2 spider joints and a slip yoke. In total there are six zerk fittings that will require greasing.

What kind of lube do you use for a propeller shaft?

Propeller shaft is what Toyota calls the driveshaft for some reason. You just need to get a grease gun and some quality lithium grease and pump some into every grease port (aka zerk) until grease starts getting purged from the u-joint boots. Depending on the model year and whether or not you have 4×4 you will have between 0 and 5 grease points.

What kind of grease does a Toyota 4Runner use?

Toyota recommends two types of grease for the spider joint and slip yoke: Spider Joint: Lithium base chassis grease, NLGI No. 2 Slip Yoke: Molybdenum-disulfide lithium base chassis grease, NLGI No. 2 or Lithium base chassis grease, NLGI No. 2

https://www.youtube.com/watch?v=JdxHjbjICWs