How do I set the timer on my Salus thermostat?

SETTING THE TIME Press and hold SET and SELECT when the RT500RF is in Normal mode for a few seconds to enter the Clock setting mode. Release both keys and the display will look like the image below: The Time and Day are displayed along with a SET indicator, with all other indicators cleared from the display.

How do I reset my Salus RT300RF?

NOTE: The Reset button must be pressed after changing jumper positions. The Reset button is accessible behind the small hinged door on the front right hand side of the Control Centre.

Why wont my Salus thermostat connect?

To test that the receiver and thermostat are paired, navigate to the Pairing Menu by choosing Menu > Pairing > TEST. If the RED and GREEN LED’s on the receiver are NOT flashing, you will need to Re-Pair the Thermostat and Receiver. To do this, slide the ON/OFF switch on the receiver to OFF and then slide it back to ON.

How do I set Salus Controls?

Press +Hr button to set number of hours for temperature override (e.g. to set up override for 3 hours, press the button 3 times). Press the + Hr button until number of hours disappears from display. Press button to activate the Manual Mode. Hold down button for 3 seconds to activate the Holiday Mode.

Why won’t my Salus thermostat connect?

How do I sync my Salus rt501rf?

To enter pairing mode press and hold SELECT for 3 sec and the thermostat will show 10SY (see right) once the thermostat is in pairing mode press and hold the sync button on the receiver (see page 14) wait for the red LED on receiver to change state then press any key to cancel and return to the main screen.

How do I know if my Salus thermostat is working?

To test that the receiver and thermostat are paired, navigate to the Pairing Menu by choosing Menu > Pairing > TEST. This will display ‘TESTING 10’ on the thermostat. If the receiver and thermostat are paired correctly, the RED and GREEN LED’s on the receiver will flash.