How many amps is a 3AG fuse?
How many amps is a 3AG fuse?
1.5 Amps
Fuse – Slow-Blow, 250V, 3AG, 0.25″ x 1.25″, Amperage: 1.5 Amps.
What does a plug fuse marked with a P mean?
non-time delay fuses
Standard non-time delay fuses are for receptacle and lighting circuits. For Canadian requirements, a type “P” fuse is used for non-motor loads and type “D” fuses are used for electric heating and cycling loads circuits. Both fuses have low melting-point temperature elements.
Where is the type T fuse?
Greg’s Mine Supply
The location on the map where the Type-T fuse is found is called Greg’s Mine Supply, which is southwest of Vault 76 and due south of Morgantown Airport. Look for a little “89” road sign on the map. Once you get to Greg’s Mine Supply, you’ll find the front door locked.
What is a class fuse?
Class CC fuses. These non-renewable fuses are current-limiting and intended for the protection of components sensitive to short-time overloads, non-inductive loads, and short-circuit protection of motor circuits. Current ratings range from 0A to 30A, and the voltage rating is 600VAC.
What are the different fuse sizes?
Size groups
| Blade size | Blade group | Common ratings (maximum current) |
|---|---|---|
| Micro3 | ATL | 5, 7.5, 10, 15 |
| LP-Mini (low profile) | APS, ATT | 2, 3, 4, 5, 7.5, 10, 15, 20, 25, 30 |
| Mini | APM, ATM | 2, 3, 4, 5, 7.5, 10, 15, 20, 25, 30 |
| Regular | APR, ATC, ATO, ATS | 0.5, 1, 2, 3, 4, 5, 7.5, 10, 15, 20, 25, 30, 35, 40 |
How can you tell if a TL fuse is blown?
Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.
How big is a 2AG glass circuit fuse?
Size 2AG ( M205 ): Length 20mm diameter 5mm. Do Not use glass type fuses as a replacement for the special ceramic types that are sometimes used in Main circuits. Glass types can explode in mains circuits when there is a fault, where as ceramic types are designed for safety. We keep around 10pcs of each type in stock.
What kind of Fuse do I need for a low voltage DC?
Low voltage DC circuits normally use a fast blow type, and Mains circuits normally require a Slow Blow type. Do Not use glass type fuses as a replacement for the special ceramic types that are sometimes used in Main circuits. Glass types can explode in mains circuits when there is a fault, where as ceramic types are designed for safety.
Which is the correct size for a fuse?
Over the years standardization of parts began to take root and a new system was adopted for sizing fuses. At that point in time, the “AG system” of fuse sized was adopted (the “AG” stood for “Automotive Glass”). There are few side notes to the above table. The 5 AG size is also commonly called a “midget” fuse.
How big are fuses for AGC and GMA?
Buss HRK. 5/8″ through 1-1/4″ long. Adjust for fuse length by selecting proper length spring. For AGC, GMA, SFE 7 1/2, SFE 14 and SFE 20 fuses. In- cludes three springs.