How much does it cost to drill a well in Colorado?

For example, Cushing & Sons Well Drilling in New Hampshire estimates an average cost of $5,000 for a complete water well system in that area, while a Colorado landowner reports costs of $14,000 to drill a 600′ well (about $23 -$24/foot) and another $7,000 -$8,000 for a constant pressure pump system with a 70′ water …

Can you drill a well in Colorado?

Prior to drilling a ground water well in Colorado, you must have a permit from the Colorado Division of Water Resources, also known as the State Engineer’s Office. Wells for most other uses, such as irrigation, are considered “non-exempt” and are administered within the priority system.

How many acres do you need for a well in Colorado?

Domestic water well permits most often require 35 acres or more and allow for outside watering of animals and limited irrigation.

What does it cost to drill a well?

Most well drillers also have a minimum charge, usually around 100ft minimum which at $45 per foot would be $4500. Drilling a water well is a long term investment and most people are reluctant to drill without knowing if they will find water, and if so at what depth.

How deep should you dig your well?

In order to allow for maximum ground filtration to remove impurities, your well depth should be at least 100 feet. As a general rule, the deeper you drill, it’s more likely that there will be minerals present.

How do you know where to drill a well?

If you want to find the the location to drill with the highest potential yield you need find the location to drill that the aquifer is the thickest and has the highest hydraulic conductivity.

What does domestic well mean in Colorado?

Domestic wells are typically associated with rural residences. These kinds of wells allow normal, indoor use in one to three residences. The permit should outline number of residences allowed to be served by the well.

Are water rights real property in Colorado?

A water right in Colorado is regarded as a real property interest akin to land for the purposes of ownership and conveyancing. Conveyance of a groundwater right requires that a “Change of Ownership” form for the well permit be submitted to the State Engineer’s Office.

How much does a 100 foot well cost?

To drill a 100-foot well for example, the cost to drill a well and add casing averages around $1,500 to $3,000 — not including permit fees. To drill a well 400 feet deep, the cost may run $6,000 to $12,000.

How much does it cost to drill a water well?

This brings the typical total for drilling a well and setting up a private water delivery system to $3,500-$20,000 or more, but an especially deep and difficult well with a complex water system can cost $20,000-$50,000 or more, depending on depth, water yield and system complexity.

What equipment is used for water well drilling?

Drilling rigs can be massive structures housing equipment used to drill water wells, oil wells, or natural gas extraction wells, or they can be small enough to be moved manually by one person and such are called augers.

How is a water well drilled?

Water well drilling can be done in a variety of ways. The simplest method is the driven well, in which one pounds a length of pipe into the earth until water is reached. The pipe is threaded, with a cap put over the top end to protect the threads from the bashing of the sledgehammer.

Can I drill a well?

You can actually drill a well fairly easily, using nothing more than PVC pipe and water. No, I didn’t invent this way, someone else did; but his method is so simple, it deserves to be shared. To start with, you have to have the right soil. Not all soil is created equal and the wrong soil will make it extremely hard to drill a well.