What is RX and TX in ifconfig?

interface stats RX packets is a total number of packets received. RX errors shows a total number of packets received with error. This includes too-long-frames errors, ring-buffer overflow errors, CRC errors, frame alignment errors, fifo overruns, and missed packets. TX packets is total number of packets transmitted.

What is RX TX Linux?

TX and RX are abbreviations for Transmit and Receive, respectively. Note that these metrics are referenced to the server being monitored; Transmit FROM this server, and Receive TO this server.

What are Tx and Rx packets?

Tx packets – displays the number of transmitted packets. Rx packets – displays the number of received packets. Tx retry, % – displays the amount of retried packets (in percentages). Rx drop, % – displays the amount of dropped packets (in percentages).

Does ifconfig work on Linux?

As soon as you will press enter, a lot of information will be displayed on the terminal screen. The ifconfig command works in the same way for finding the IP address of a device using terminal in Linux as ipconfig command works for finding the IP address of a device using command prompt in Windows.

What does ifconfig do in Linux?

Ifconfig is used to configure the kernel-resident network interfaces. It is used at boot time to set up interfaces as necessary. After that, it is usually only needed when debugging or when system tuning is needed. If no arguments are given, ifconfig displays the status of the currently active interfaces.

What is Rx and Dx?

Rx stands for the Latin Recipe. Dx is Diagnosis. Tx is Treatment. Hx is History. Sx is Symptoms.

What is RX PKT?

RX Packet Rate (Pkt/s) Displays the rate for receiving data in packets per second. Total TX Bytes. Displays the bytes of packets transmitted by the user who owns the IP address.

How does Tx and Rx work?

The Tx level is the power in decibels per milliwatt (dBm) at which a modem transmits its signal. The Rx level is the power in dBm of the received signal. The server modems normally transmit at -13 dBm by default. Ideally, the Rx level should be in the range of -18 to -25 dBm.

What is RX and TX frequency?

For ANY transceiver RX is the receive frequency and TX is the transmit frequency.

How do I use ifconfig in Linux?

To assign an IP address to a specific interface, use the following command with an interface name (eth0) and ip address that you want to set. For example, “ifconfig eth0 172.16. 25.125” will set the IP address to interface eth0.

Why does Linux use ifconfig?

ifconfig(interface configuration) command is used to configure the kernel-resident network interfaces. It is used at the boot time to set up the interfaces as necessary. After that, it is usually used when needed during debugging or when you need system tuning.